The Hitech 100mm Modular Holder System is a customisable three slot holder system that can hold 1, 2, or 3 Hitech 100mm wide filters. One of the slots can then be modified to hold a 4mm glass filter, by inserting the plain spacers. Compatible with the Lee Big Stopper and Lee Little Stopper filters.
The Hitech 100mm Modular Holder System
- 1 x Back Plate
- 1 x Brass Clamp Screw
- 6 x Brass Screw (in both Long & Short versions)
- 6 x Brass Nuts (Insert)
- 6 x Spring Nylon Spacers (to allow you to create 3 filter slots)
- 2 x Plain Spacers (to allow you to extend one filter slot to accommodate 4mm filters)
For 4mm Glass Filters
Insert two brass screws into one side of the Back Plate. Take the Plain Spacer, and thread this onto the screws. Next, take a Spring Spacer and thread this onto the screws. Continue to thread Plain (extra spacers are sold separately) and Spring Spacers onto the screws until you reach the required number of slots. Finally, screw the Brass Inserts (Nuts) onto the screws & tighten to secure the slots in place. Repeat on the other side. Your holder is now ready to use.
For Hitech Filters
Insert the two brass screws into one side of the Back Plate. Take the Spring Spacer and thread onto the screws. Repeat until required numbers of slots have been created. Finally, screw the Brass Inserts (Nuts) onto the screws & tighten to secure the slots in place. Repeat on the other side. Your holder is now ready to use.
Please note that for your convenience, this holder will come fully assembled.
Users of the Hitech 100 Metal Modular Holder have to remember to remove the 'spacer' fitted in the last slot for a proper fit for 1.5mm resin filters. The spacer is only included for users who may also use the Hitech 4mm Glass filters.
Back to top
Back to top
|For Use With
||Hitech 100mm filtes
||Modular Holder System